↓Skip to main content

Taming Common-Mode Current: Winding a Custom Choke for the DX Commander

·3 mins
Note: This is a sample post generated for testing the new archetype and page bundle layout.

Operating QRP out of QF56 with the Yaesu FT-818 means every single watt has to count. Whether I’m chasing contacts on FT8 or practicing CW with the straight key, ensuring RF actually radiates from the antenna rather than traveling back down the feedline is critical for both signal efficiency and keeping the home network happy.

My primary HF antenna is the DX Commander Classic. It’s a fantastic vertical system—especially since the 40-meter wire element elegantly resonates on the 15-meter band without needing a dedicated 15m wire. However, vertical antennas with radial fields can sometimes suffer from common-mode current creeping back down the coaxial shield. To nip this in the bud, I set out to build a dedicated inline common-mode feedline choke.

The Build Materials #

I opted for a heavy-duty approach using a large ferrite core. The parts list was straightforward:

  • A genuine FT240-31 toroid core (the mix 31 ferrite is excellent for lower HF bands, though an FT240-43 is a solid alternative for higher frequencies).
  • Stranded MIL-C-17 RG-58C/U coaxial cable, which is flexible enough to tightly wrap around the core without deforming the dielectric.
  • Quality crimp-on PL-259 connectors and some weatherproofing heat shrink.

Winding the toroid is an exercise in patience. To maximize the choking impedance, I used the W1JR crossover winding method. This involves winding half the turns on one side of the toroid, crossing the coax over to the opposite side, and winding the remaining turns in the same direction. This technique keeps the input and output connectors on opposite sides of the choke, reducing stray capacitance across the toroid.

Verification with the NanoVNA-H4 #

Building a choke is only half the job; you have to measure it to know if it actually works. You can’t just guess at RF physics.

I hooked the completed choke up to the NanoVNA-H4. To measure common-mode impedance, you connect the center pin and shield of the VNA’s CH0 (S11) to one end of the choke’s shield, and the CH1 (S21) to the other end of the choke’s shield.

The sweep across the HF bands was highly satisfying. The FT240-31 core paired with the RG-58C/U provided over 2,000 ohms of choking impedance right where I needed it most, nicely covering the 40m and 80m bands (which helps massively now that I’ve implemented the 80m Inverted-L modification on the DX Commander).

On-Air Results #

Putting it in line between the FT-818 and the DX Commander immediately lowered the noise floor slightly on the receiver end. More importantly, when transmitting digital modes at 5 watts, there is zero evidence of RF in the shack. The energy is going exactly where it belongs—into the ether.

As I continue studying for the Advanced license, having a hands-on grasp of complex impedance, AC circuit mathematics, and resonance isn’t just syllabus material—it’s what makes the station actually work.